Dilshan R Jayakody’s Web Log

This project is about a single-channel microphone echo generator circuit. This circuit builds around the Holtek HT8970 echo effect generator IC. It offers complete control of the echo effect by providing delay, mix, and output level adjustments.  HT8970 is an echo/surround sound effect generator IC with 20Kb SRAM. It also contains the built-in VCO stage, AD, and DA converters. The chip costs less than 0.5 US$ and is commonly available in the market. Prototype build of the echo effect generator circuit. The given schematic offers a maximum of 320ms time delay and works with a single-rail 9V DC power supply.  In addition to the HT8970 integrated circuit, this circuit uses an NJM4558 op-amp to amplify the input and output audio signals. HT7150 voltage regulator uses in this design to power up the HT8970 IC. The HT7150 is a low-power 5V regulator IC from Holtek, the same maker of the HT8970 IC. Top view of the prototype build. The circuit designs to work with 500Ω dynamic mic...

YALI ( Yet Another LCD Interface ) is an open-source project to provide a universal interface to drive the popular Hitachi HD44780 LCD controller. This module supports 3.3V and 5V MCUs and hardware development platforms, including Arduino, STM32, PIC, and ESP8266. YALI hardware module. The hardware module of this project consists of a 74HCT08 CMOS AND gate and a 74HC595 8-bit serial-in, parallel-out shift register. This module uses the MP1540 step-up converter to power the LCD unit connected to the system. The module has the jumper to select 3.3V or 5V DC power input.  Bottom side of the YALI hardware module. The YALI library is developed using C and is designed to be easily integrated with any C/C++ embedded toolchain. At the initial design stages, this library was successfully tested with all Arduino development boards, NodeMCU , STM32 Blue Pill , etc. The target system must have three digital output lines with 5V or 3.3V logic levels to interface with the YALI module. As m...