Dilshan R Jayakody’s Web Log

This quick post is about the verification script which I did to test the PT8211 DAC functionality. This script is designed to work with Arduino boards and, I tested with Arduino Due and Arduino Mega 2560 boards. The script is self-explanatory, and it emulates the I2S interface and communicates with the PT8211 DAC. The output waveform of PT8211 on Arduino Due board. With this script, PT8211 generate sine wave in both channels. The frequency of the waveform is dependent on the clock frequency of the Arduino board. In Due board, PT8211 generates 0.052kHz sine wave on both channels. Connections between PT8211 and Arduino. The test setup is quite straightforward. I2S and power pins of PT8211 need to connect to the Arduino board in the following order: Serial clock ( BCK ) - Pin 22 Channel selector ( WS ) - Pin 23 Data ( DIN ) - Pin 24 VCC - 5V (Mega 2560 board) 3.3V (Due board) GND - GND Left and right channels of the DAC is connected to oscilloscope or frequenc...

TFA9842AJ is quiet old 7.5W audio power amplifier introduced by NXP . This amplifier IC is no longer produced by NXP, but still, it's available to purchase in many places, which including eBay , AliExpress , Amazon , etc. NXP TFA9842AJ Power amplifier IC. I tested a couple of TFA9842AJ based amplifiers in the last couple of years. The main reason I liked TFA9842AJ is its simple, clean design, wide operating voltage, and high-quality bass-rich audio output. Thanks to it's built-in DC volume control circuit this audio amplifier can easily interface with MCU. In this article, we provide a generic TFA9842AJ module which works with most of Arduino boards, MCUs and SOCs. Schematic of the TFA9842AJ module. As illustrated above, this system consists of LM321 operational amplifier and TFA9842AJ IC. To support both 5V and 3.3V logic inputs we introduce logical level selection jumper ( J2 ) into this design. To control the volume PWM input must apply to the J1 . In this...